1.  TOP GLASS - remove it by opening the machines main door and carefully lifting the  old glass holder up and out of the cabinet frame. Replace with new top glass.

2.  REEL GLASS - to remove the old piece you will need to remove the florescent lamp bulb and then removing the florescent fixture screws and finally the fixture itself. Once the fixture is removed you should be able to grab the old reel glass on both sides and carefully pull it out of the lower holder and replace it with the new glass.

3.  BELLY GLASS - is replaced by locating the glass door release knob which is located on the main machine door. Simply pull the knob straight out and flip the frame of the lower glass assembly down. Remove the small screws (up to 4 of them) from the light and glass holder and carefully slide the old glass out of the machine. When installing the new glass be sure that it is right side up when the assembly is closed before tightening the screws that hold it in place.

4.  REEL STRIPS - each of our 6 piece kits come with 3 reel strips and each one has a number on the bottom of the strip, the strips must be placed on the correct reel basket (lower number placed on the left reel basket and so on), so be sure to match them up correctly to ensure your game will work properly.

The reel strips have small notches cut in them near the bottom. There is also a matching notch on each reel basket. The notches on both the reel strips and the reel baskets must be installed so that their notches are aligned in the correct positions in their reel baskets. 

The easiest way to locate the notches in the reel baskets is to place a reel strip into the left side groove of the reel basket that it is to be installed into and hold the strip at a 45 degree angle to the basket with one hand and use the other hand to rotate the reel basket slowly until you feel it catch on the notch. Then, proceed to roll the strip around the back side of the reel basket and as you do tuck both sides into the grooves of the reel basket until you come back around to where you started.

At this time you want to make sure that the end of the reel strip overlaps the other end of the strip and that they are seated together with clear scotch tape to secure the strip to itself. If you did this correctly, you will not be able to see the notches in the strips after you are finished and the reel should spin straight and true. numbers on the bottoms or back sides of the strips so that they are installed in the correct reel.